Spring testers

Compare

A very simple, economical system for checking compression springs. The measurement head gives the force applied, the displacement sensor shows the flexion or height measured under load.

Specification Sheet: Spring Tester 1

Compare

A system specially designed for high precision measurements of compression. With its high reduction ratio, this manually operated test stand is well suited for the measurement of small springs with low force levels.

Compare

With its STENTOR II motorized test stand, fixed plate and adjustable plate, the Springtest 3 can be used to test high capacity tension and compression springs.

Compare

With its STENTOR II motorized test stand, fixed plate and adjustable plate, the Springtest 3 can be used to test high capacity tension and compression springs up to 2000 N.

Compare

Dedicated to controls on torsion springs, this manual torsion test stand is fitted with a Centor Dual. It shows the torque and angle values on the same display. It is supplied with a set of bored plates and fitted with locating pins to hold the springs in place.

Compare

The SPRINGTEST T1 series is a very simple and economical system for checking compression springs in one point. The force gauge gives the force applied, the displacement sensor on the side shows the flexion or height measured under load.

Specification Sheet: SPRINGTEST T1